Hi,
I'm thinking of constructing a cephalotus tank and was wondering if there's any advice out there? In this thread Martin Hingst uses a 40x25x25cm tank. Is this a reasonable size? Any drawbacks etc? This example is glass but I was thinking of using acrylic sheet cut to size and glued. Does this sound OK? Any suggestions on sheet thickness?
Cheers,
Change
Advice wanted on ceph tank
Started by
linuxman
, Apr 07 2012 12:37 PM
#1
Posted 07 April 2012 - 12:37 PM
#2
Posted 07 April 2012 - 15:03 PM
The thin acrylic sheet is no good for your tank,its too bendy and can go brittle after a bit.It also scratches easily.
Lexan,would be better,its 1/4" thick and you can hit it with a hammer and it wont break,but its expensive and hard to cut to size unless you have a table or wall saw. It still scratches easily too.
An old or second hand fish tank would be a lot easier and probably cheaper in the long run,plus you don't have to mess about siliconing it together and it will be well cured and no chance of any chemicals leaching into your compost.
ada
Lexan,would be better,its 1/4" thick and you can hit it with a hammer and it wont break,but its expensive and hard to cut to size unless you have a table or wall saw. It still scratches easily too.
An old or second hand fish tank would be a lot easier and probably cheaper in the long run,plus you don't have to mess about siliconing it together and it will be well cured and no chance of any chemicals leaching into your compost.
ada
#3
Posted 07 April 2012 - 20:41 PM
Here's a bad panoramic shot of my tank. It's an 18" glass tank, lit with two daylight CFL. It's still maturing, but the Cephalotus are starting to produce adult pitchers.


#4
Posted 12 April 2012 - 10:36 AM
Very nice mobile!
What kind of soil have you got there? And is there drainage of any kind?
What kind of soil have you got there? And is there drainage of any kind?
#5
Posted 12 April 2012 - 14:57 PM
Looking good Carl.
Are they all seed grown or divisions of the same plant?
ada
Are they all seed grown or divisions of the same plant?
ada
#6
Posted 12 April 2012 - 17:36 PM
#7
Posted 12 April 2012 - 18:48 PM
It will turn out to be a stunning setup after couple of good growing years!
#8
Posted 13 April 2012 - 10:37 AM
#9
Posted 28 April 2012 - 15:05 PM
This is what I've finally come up with using a 'starter' aquarium. The idea was to create a sort of seepage bog - hence the watering tube. I drilled several holes down its length so all depths get some water. Unfortunately I suspect the holes should have been a tad smaller as the water drains too quickly. Time will tell.
I've planted it with 6 of the 'Eden Black' selfed seedlings I've grown. Now I just need to wait 10 years to get a good show.


I've planted it with 6 of the 'Eden Black' selfed seedlings I've grown. Now I just need to wait 10 years to get a good show.


#10
Posted 28 April 2012 - 15:35 PM
Do you have a membrane between the soil and the LECA? My first attempt at a very similar setup (shown above) didn't have one and I found that the soil washed into the LECA, which somewhat defeated the object of using it. I rebuilt mine by placing a weed control membrane between the soil and the LECA, which allows the water to pass through, but not the soil.
#11
Posted 28 April 2012 - 15:40 PM
mobile, on 28 April 2012 - 15:35 PM, said:
Do you have a membrane between the soil and the LECA? My first attempt at a very similar setup (shown above) didn't have one and I found that the soil washed into the LECA, which somewhat defeated the object of using it. I rebuilt mine by placing a weed control membrane between the soil and the LECA, which allows the water to pass through, but not the soil.







Back to top










